Repairs
Repair & Maintenance
Think of this as the general practice side of the trade. Sticking doors, uneven travel, a grinding sound on the way up, a gap you can see daylight through: we look at the whole door, find what changed, and correct it.
Which one do I need?
- Backing out in a hurry, the bumper tapped the bottom section.Garage Door Safety Inspection
- The door lands with a thud you can feel through the kitchen floor, and sometimes it bounces back up a few centimetres before settling.Garage Door Tune-Up
- The rollers on the door have been squealing for months.Off-Track Garage Door Reset
- From outside, the horizontal groove between two sections now steps sideways by a centimetre.Garage Door Panel Replacement
- One end of the bottom seal has slipped out of its channel and hangs down like a loose shoelace.Garage Door Bottom Seal Replacement
- Dry leaves keep appearing in the same corner inside the garage, and this fall there were mouse droppings along the wall beside the door.Garage Door Perimeter Weatherstrip
Repair & Maintenance
Inspection, adjustment, sealing, and section-level repairs.
Garage Door Safety Inspection
Springs, cables and drums, looked at and left alone
The counterbalance gets a careful look and nothing more during the inspection. On a torsion door the technician checks the spring coil for a gap, rust or a stretched section, confirms the cone set screws and centre bearing look sound, and follows each cable from the drum to the bottom bracket looking for broken wires, a rust bloom near the loop or a slack side. The drum wrap is checked for a single neat layer.
On an extension door the springs, pulleys and containment cables are examined the same way. Any adjustment to these parts is a separate, planned job matched to that system, torsion tension controlled with winding bars rather than simply released; the inspection records their condition.